Trending Topics #HomeCoffeeRoasting #dc3drawings #thebible
DC-3 Engine Cowls – Taming the Top Flite Accessory
Old DC-3 Sitting Along Side Chino,CA Airport Real DC-3 airplanes are powered by two Wright R-1820 Cyclone radial piston engines. The radio controlled model I am building is powered by two E-Flite Power 15 electric motors ho
DC-3 Nacelles & Foam Sanding
Each of my DC-3 nacelle boxes are designed to house the landing gear, servo and speed control. Once assembled, the boxes are then mounted onto the wings. Then foam is glued on each of the 4 sides and then shaped to look like
Douglas DC-3 Retractable Landing Gear
Douglas DC-3 Retractable Landing Gear My scratch built Radio Controlled Douglas DC-3 is in progress and I am currently working on the cowls for the 86" wingspan transport/airliner. Usually, when a modeler uses retractable ge
Hot-Wire Foam Cutting Technique
Hotwire Power Supply Ready To GO People use foam to create all kinds of arts and crafts projects. Homecoming floats, replica sculptures and even building facades are made with foam. I use foam to build radio controlled airpl
Complete Bible Summary
Experience The Whole Bible!90 Summary Devotionals
I read the entire Bible in 90 days and blogged about it.
Experience the best tasting coffee possible
Learn where to get your beans and how to roast themLearn to roast your own coffee!
Craft coffee like the pros!
Learn How To Scratch Build Your Own RC Fighter Plane!
See it built - Step by Step InstructionsHow to build a P-51 Mustang
Over 50 MPH!
3-View Drawings for the DC-3 Project
DC-3 3-Views Scratch building an RC airplane is a lot of fun and very rewarding. This DC-3 Project has been a great learning experience for me. I have scratch built a couple of aircraft from Mark Rittinger plans and they a
DC-3 Outer Wing Section
DC-3 Foam Cores Another update on the DC-3. The outer wing section has been made which now brings the DC-3 wingspan to a total of about 86″ (over 7 feet). Foam cores were cut using the same airfoil profile I us
Spektrum DX-7 Lipo Conversion
Spektrum DX-7 Transmitter The old days of worrying about getting your remote controlled airplane shot down by another pilot’s radio because of crossed frequencies is long past. Now, 2.4 ghz digital transmitters a
DC-3 Fuselage & Wing Center Section
It has been a while since I posted anything on my Douglas DC-3 progress. The foam fuselage has been completely assembled and the two main halves have been joined together. After more sanding it was fiberglassed using 1 ou
Rather than post your comments, I welcome your thoughts or questions. You can write to me here.
DC-3 Rudder
Progress on the DC-3 has been slow but sure. The rudder is built and ready for final finishing before it is installed onto the fuselage. The DC-3 rudder is unique because the hing location is inward from the leading edge of
Mike’s DC-3
Douglas DC-3 I am currently building a Radio controlled Douglas Dc-3 airplane. I made the drawings for this using Adobe Illustrator and started the construction process over a year ago. I hope to finish building the plane
Mike’s P-51B
The last build project that I have completed is a P-51 Mustang from Mark Rittinger plans. It is made mostly from balsa and some foam. The plane has a 42″ wingspan and flies using an electric motor and lithiu
Mike’s P-47D
One of my hobbies is flying RC (Radio Controlled) Airplanes. I started this hobby in my early 20's and it has been with me since. One fun aspect of the hobby is to build the airplane, not just fly it. Taking it one step fur